数字仿真

  • 网络Digital Simulation;RTDS
数字仿真数字仿真
  1. GIS支持下的滑坡运动过程数字仿真

    Digital simulation model of landslide motion process under GIS support

  2. 基于MATLAB的同步电机步进运动数字仿真

    Digital simulation of step motion of synchronous motor based on MATLAB

  3. GIS支持下降雨滑坡的启动机制研究与数字仿真

    GIS-aided study and numerical simulation of initiation mechanism of landslide due to precipitation

  4. 并联输出DC/DC谐振变换器的稳态分析和数字仿真

    Steady-State Analysis and Digital Simulation of the Parallel DC / DC Resonant Converter

  5. 基于MATLAB的液压系统数字仿真研究

    The Digital Simulation of Hydraulic Pressure System Based on MATLAB

  6. 单相电压型PWM逆变器的数学模型与数字仿真

    A Maths Model and Digital Simulation of Single-phase Voltage PWM Inverter

  7. 并设计了多门限的PID控制算法,对飞机刹车系统进行了整体的数字仿真。

    And designing the PID algorithm with pressure adjustable , proceeded the overall digit simulation .

  8. 最后以NewEngland和等值系统系统为例进行数字仿真,验证了新的分层电压控制方案的有效性。

    At last , the validity of new layered voltage control project is proved by simulation to the New England system and equivalent system .

  9. 纯滞后MIMO离散系统建模及数字仿真

    Modeling and Digital Simulation of MIMO Discrete System with Pure Time Delay

  10. 在对电流互感器(CT)暂态过程的数字仿真中,电流互感器的铁芯的非线性磁化特性必须加以考虑。

    The nonlinear magnetization characteristic of current transformer ( CT ) iron core must be considered when simulating the CT 's transients behavior .

  11. 不接地系统中电磁式PT异常运行的数字仿真分析

    Digital Simulation Study and Analysis on Abnormity of Electromagnetic Potential Transformer in Isolated Neutral System

  12. 根据故障状态下的气动数据建立线性和非线性模型,用经典控制律设计方法针对高生存力无人机设计了在典型单故障状态下的控制律,并用matlab进行了数字仿真。

    HALE UAV control law for typical single failure situation is designed in classical method , and simulated by matlab .

  13. 进行数字仿真试验,以检验该系统是否可以更有效传输二进制PAM信号。

    The simulation indicates the system can process the signal availably .

  14. 设计了姿态匹配传递对准的H∞滤波器,并且通过数字仿真分析验证了姿态匹配传递对准的H∞滤波器的性能。

    The H ∞ filtering of the attitude matching transfer alignment is designed . The simulation validates the performance of the H ∞ filtering .

  15. ARMA模型用于多变量随机过程的数字仿真

    ARMA Model for Digital Simulation of Multivariate Random Processes

  16. 10kV电网TV铁磁谐振过电压数字仿真及研究

    The Digital Simulation and Study of TV Ferroresonance Over Voltage in 10 kV Power Network

  17. 用于AVR闭环测试的同步发电机组数字仿真

    Digital Simulation of Synchronous Generator for AVR Closed-loop Tests

  18. 采用Matlab数字仿真的方法得到了电流观测器的值,并与直接电流控制检测的实际电流波形进行了对比。

    The value of the cur-rent observer is acquired by digital simulation in Matlab and compared with the actual current wave con-trolled by direct current control scheme .

  19. 大量EMTP和RTDS数字仿真实验表明该方案具有很强的可行性和工程应用价值。

    EMTP and RTDS digital simulations show its good feasibility and engineering value .

  20. 通过数字仿真分别辨识了一个二阶系统和四阶系统,研究了频率指数m和调制函数阶次n对辨识精度的影响。

    Two models with two orders and four orders system are estimated , and the influence of the frequency index m and the modulating function order n to the accuracy of identification is discussed .

  21. 本文研究非线性Stiff液压系统的数字仿真。文章定量地论证了液压系统的病态性和Gear的Stiff稳定方法的有效性。

    This paper studies digital simulation of nonlinear stiff systems in hydraulics , Stiffness of hydraulic systems and efficiency of the Gear 's stiff stable method are demonstrated quantitatively .

  22. 基于RTDS的交直流系统实时数字仿真方法研究与实现

    Research and Implementation of Real-Time Digital Simulation Method of AC-DC Power System Based on RTDS

  23. 基于BPF的分布系统数字仿真方法

    Digital Simulation of Distributed Systems Based on BPF

  24. 文中提出了一种新的估计方法&替换百分点法,并运用MonteCarlo数字仿真对估计的置信度和精度进行了分析,研究结果表明此方法具有工程应用价值。

    The Monte Carlo simulation is used . To study the confidence level and accuracy of this method . The result shows that the method is satisfactory for engineering purpose .

  25. 实时数字仿真装置RTDS介绍

    Introduction of Real-Time Digit Simulation Device-RTDS

  26. 并将此设计应用于交流电机矢量控制系统中,数字仿真实验表明,此方法设计的控制器可克服传统PID控制器在电机参数改变时控制性能差等不足,鲁棒性强。

    The result of digital simulation shows that the designed scheme overcomes the control defect of conventional PID controller , with the motor parameters varying , prefect in dynamic performance , strong in robustness .

  27. TDI-CCD推扫成像传递函数的数字仿真与分析

    Numeric Simulation and Analysis of MTF in TDI-CCD Push-sweeping imaging

  28. 数字仿真表明:由中等精度的陀螺仪和加速度计以及GPS组成的组合导航系统平台水平误差角小,定位精度高,能够满足重力测量和导航要求。

    Digital simulation shows that the integrated navigation system of moderate precision accelerometers , gyroscopes and GPS , has small platform angle error , high positioning precision and can meet the requirements of gravity measuring and navigation .

  29. 在对这些方法基本原理分析的基础上做了EMTP数字仿真及结果分析。

    Various numerical simulations with Electromagnetic Transients Analysis Program ( EMTP ) were made and the results were analysed .

  30. 500kV输电系统的物理仿真与数字仿真

    Physical and numerical simulation for 500 kV transmission system