危险点

wēi xiǎn diǎn
  • peril point;dangerous point
危险点危险点
危险点[wēi xiǎn diǎn]
  1. 分析了影响热锻模热负荷与危险点处热应力的因素。

    The factors of influencing the thermal load and thermal stress at the peril point of hot forging die were analyzed .

  2. 根据强度分析确定危险点的应力值,采用名义应力法对镁合金车轮进行疲劳寿命预测。

    Nominal stress method was been adopted to predict the fatigue life of magnesium alloy wheel by the stress of peril point .

  3. 尽管它们目前还不是系统性危险点,但imf对这种可能性发出了警告。

    While these are not yet systemic hot spots , the IMF warned they could become so .

  4. 220kVBOT开关站继电保护危险点分析

    Analysis about Dangerous Point on Relay Protection in 220 kV BOT Switching Station

  5. 当通道表面粗糙度Ra为1.6μm时,模具危险点工作应力不会超过变形体流动应力的4.5倍。

    The maximum stress on the die will not exceed 4.5 times of the flow stress , when channel surface roughness Ra is 1.6 μ m.

  6. 采用WORKBENCH获得驱动桥半轴在受最大扭转载荷时的整体应力分布,校核其结构强度并确定半轴的危险点。

    Analyze rear axle by ANSYS WORKBENCH to get its maximum overall stress distribution , determine whether it meets the requirements of its structural strength and the risk of axle-point .

  7. 然后,利用MARC软件求出传输塔在只承受自重和电缆载荷情况下的应力和位移,并找出危险点;

    Secondly , MARC software was used to obtain stress and displacement of transmission tower under the load of only dead weight and cables , and to find the identify risk point .

  8. YBT模型上最容易发生皱曲的临界危险点是模型的中心;

    The center of the YBT model is the most possible critical buckling instability point ;

  9. 探讨在电子海图中,使用GIS空间分析函数自动判断计划航线的偏航极限范围内是否存在危险点、线、面的方法,为航线设计起决策参考,在航行过程中,起实时航路监视作用。

    In this paper a method of using GIS spatial analysis function to realize detecting danger points , lines and planes within a limited region of deviation in Electronic Chart automatically so as to provide the reference for the decision making of routing design and navigation monitoring .

  10. 通过模拟分析,得出了药柱VONMISES应力、应变分布图以及危险点的位置,结合相应的破坏判断依据,表明结构的完整性可以得到保证。

    By numerical computation and simulation , the distribution and dangerous point of von mises stress / strain are found and compared with the corresponding damage criteria . The results show that structural integrity can be guaranteed .

  11. 因此,现行以Hertz理论为基础设计齿轮传动接触疲劳强度的做法有待完善。(2)啮入点是齿轮传动啮合线上的危险点,因为该处的油膜厚度最小且接触应力最大。

    So , the contact fatigue strength design of gear transmission which based on Hertz theory need to improve . ( 2 ) The approach point is the danger point on meshing line , because the minimum oil film thickness and the maximum contact stress at this point .

  12. 将危险点预控原理应用于供电企业安全管理中,研制了新的软件危险点预控管理系统(DPFCMS)。

    Applying the principle of the dangerous points forecast and control into the security management of the power supply enterprise , the new software is researched and manufactured dangerous points forecast and control management system ( DPFCMS ) .

  13. 介绍了某电厂125MW机组的调峰试验,包括试验的基本内容、各试验工况中转子危险点的应力谱及转子的寿命损耗值;

    Described in this paper is the peak load shaving operation test of a 125 MW steam turbine unit , which includes : basic contents of the test , the stress spectrum of rotor dangerous points under various test conditions and rotor service life loss evaluation .

  14. 中性点是危险点,但不是能量陷落点。

    Neutral point is dangerous but is not energy trap point .

  15. 城区电网调度危险点分析及应对措施

    Analysis and Countermeasures of the Dangers in Beijing Power GRID Dispatch

  16. 关于双圆弧齿轮断齿危险点的探讨

    Discussion on the Dangerous Tooth Breakage on Double Circular-Arc Tooth Gear

  17. 新设备启动过程中的危险点分析及处理对策

    Analysis and Countermeasures about Risk Points in Startup of New Equipment

  18. 危险点分析预控理论在锅炉设备中的应用

    The Application of Risk Spot Analysis Pre-control Theory on Boiler

  19. 浅谈电网调度工作危险点预控

    Discussion on Preventive Control of Dangerous Spot in Power Grid Dispatching Work

  20. 煤矿生产中事故危险点的控制

    Control of the accident danger spots in coal mine production

  21. 驾驶危险点的处理分析

    The Analysis of the Dangerous Driving Points ' Disposal Model

  22. 危险点分析及其在发电企业安全管理上的应用

    The Risk Analysis and Safety Management in the Power Generation Business Applications

  23. 电流互感器停用状态的危险点分析与控制

    Analyze and Control the Dangerous Points of Current Transformer under Off-duty Condition

  24. 同时得出了药柱危险点的位置。

    Meanwhile , the grains danger position is given .

  25. 道路交通事故危险点鉴别的研究

    Study on Discrimination of Traffic Accident Black Spot

  26. 塔式起重机起重臂危险点的确定

    Confirm danger points of jib-boom on tower crane

  27. 正常国人骨盆易损部位(或危险点)应力应变分布的实验研究

    Experimental Study of Distribution of Stress and Strain on Pelvis in Normal Chinese Adult

  28. 提出了危险点的压力控制措施。

    In the paper , pressure control method for danger point has been presented .

  29. 继电保护整定计算的危险点分析

    Analyzing The Risk Point of Relay Protection Setting

  30. 关键生产装置和重点生产部位危险点的划分和管理

    Danger Division and its Management in the Key Production Unit and Significant Production Section