温度分布

  • 网络Temperature distribution;Temperature profile
温度分布温度分布
  1. 采用辐射型CT算法的燃烧火焰温度分布测量

    Measurement of Temperature Distribution in Conbustion Flame Using Infrared Emission CT

  2. 利用GIS方法建立山区温度分布模型

    Using GIS to Establish Temperature Distribution Model in Mountain Area

  3. 影响CCD相机温度分布的因素分析

    Analysis for Some Factors Affecting the Temperature Distribution of a CCD Camera

  4. LD侧泵激光器抽运光和温度分布数值研究

    Simulation of Absorbed Power and Temperature Distribution in LD Side-pumped Laser

  5. 平均温度分布随时间变化时的Bénard对流

    The Benard Convection in a Layer of Fluid with a Time - Dependent Mean Temperature

  6. CVD反应器中的轴向温度分布严重影响AlN粒子合成过程中的化学反应速率、成核速率和生长速率;

    The chemical reaction rate , nucleation rate and growth rate were strongly influenced by the axial temperature profile .

  7. 通过MatLab在若干导热过程实例中的应用,探讨稳态与动态传热过程中温度分布、传热量、热通量等参数的求解与分析方法。

    The method of solution and analysis of temperature distribution , rate of heat transfer and heat flux was discussed by application of MatLab in several example of conduction .

  8. 由于在液氮温区附近氦气高低压焓差不平衡,导致G-M机蓄冷器中温度分布出现低温平台。

    The disequilibrium of the enthalpy difference of helium at liquid - helium temperature region results in that the temperature distribution in the regenerator of a GM refrigerator forms a platform .

  9. 文中首先研究了土壤温度分布特性,确定了大地原始温度分布的计算式;野生型E(W~(?)

    The characteristics of soil temperature distribution are studied at the beginning of the paper , and the computational model of original soil temperature field distribution is established . The original E ( w (?)

  10. 边界密度和温度分布变陡。事实上,该系统可广泛应用于进一步研究MHD行为,粒子和能量输运等。

    Such a system would be widely used to further investigate MHD activity , particle and energy transport , diffusion and so on .

  11. 提出计算上座率的概念,用计算流体动力学(CFD)技术对不同上座率下观众席温度分布进行预测和评价,得到了符合最佳技术经济条件的计算上座率。

    Proposes a calculated-attendance concept , evaluates and numerically simulates the temperature distribution of the audience area under different attendance rates , recommends the calculated-attendance-rate conforming with the optimum efficiency .

  12. 计算结果表明:有烟气再循环时,炉内平均温度分布和最大温度分布整体明显降低:炉膛出口CO2浓度有一定幅度的上升,O2浓度了较大幅度的下降;

    The computed result indicated that , the flue gas recycle boiler 's average temperature distribution and the maximum temperature distribution whole obviously reduces . The flue gas recycle boiler outlet CO_2 density had risen and O_2 density had dropped .

  13. WNS型燃油(气)锅炉炉内热流分布及温度分布的数值模拟

    Numerical simulation of heat-flux and temperature distributions in the furnace of an oil / gas-fired WNS boiler

  14. 目的在肌肉等效体模及Beagle犬颈段食管中测定ZRL-Ⅱ型食管腔内加热辐射器的温度分布,探讨其热场分布能否满足食管癌加热治疗的临床需要。

    Objective To assess the temperature distribution of the ZRL - ⅱ radiofrequency intraluminal applicator for esophagus hyperthermia in the muscle-equivalent phantom and Beagle dogs ' cervical esophagus .

  15. 通过有限差分法,利用Visualc++6.0建立直接水冷法(DC)AZ31镁合金连铸过程的数学模型,该模型可预测铸锭以及底模的温度分布。

    A mathematical model of DC casting process for magnesium billets was developed to predict the temperature in the billet and dummy block using Microsoft Visual C + + 6.0 and finite difference method ( FDM ) .

  16. 对背部开有不同深度、不同直径沉孔缺陷的平板表面采用恒定热流加热。使用有限元分析软件Ansys计算得到表面温度分布云图和温升。

    Finite element analysis software Ansys , was used to calculate the temperature field of the plates with back sinking hole defects of different depth and diameter under constant heating condition , and surface temperature cloudy map and temperature rise were obtained .

  17. 以计算机计算Al、Cu及0.06C钢在高应变速率下发生剪切时,在剪切带中的温度分布及冷却速率。

    The temperature distribution under shear with a high strain rate and the cooling rate of the shear bands of Al , Cu and 0.06 C steel have been calculated using a computer .

  18. 用有限元软件ANSYS模拟了4.2K冷质量支撑件的温度分布情况,同时得到了其导热漏热,并与理论计算进行了比较。

    The temperature distribution of the support for the 4.2K cold mass has been simulated by ANSYS , and its heat flux has been simulated and compared with the theoretical results presented preciously .

  19. 计算出了该分形网络通道的最优化结构参数,并定量地分析了冷却水流量和热负荷对DMFC堆温度分布的影响。

    Optimum structural parameters of the fractal network channels are calculated , and the effect of flux of cooling water and heat load on the temperature distribution in the stacks quantitatively analyzed .

  20. 采用FDS分析火灾下室内空气温度分布与开口因子及火源功率的关系,与采用我国规范计算的结果进行比较,指出相关规范的局限性和不足。

    The relation of temperature in compartment fire with ventilation factor and heat release rate dose was analyzed using FDS . The results were compared with that calculated according domestic standard .

  21. 建立了热梯度法化学气相渗工艺(CVI)模型,计算了圆筒炭毡内的温度分布,给出热梯度法CVI工艺沉积温度的控制方法。

    The technological model of thermal gradient CVI was presented . Based on this model , the temperature distribution within a cylindrical carbon felt was calculated , and the method for controlling the deposition temperature in thermal gradient CVI was suggested .

  22. 本文在理论分析和试验研究的基础上,作为对双色测温法的改进,提出了一种迭代算法&双色校正法,并将该方法应用于面阵CCD测量高温火焰温度分布的系统中。

    As an innovation for bicolorimetric method , this article , based on theoretical analysis and experimental research , advanced an iterative algorithm & adjustment for the bicolorimetric method , and applied it to the experimental system for the measurement of flame temperature field , using plane surface array CCD .

  23. 将高性能的传热元件热管应用于生物反应器开发出来的20L热管生物反应器具有反应器的温度分布均匀、传热效率高等优点。

    20L Heat pipe bioreactor is exploited using high performance heat transfer element-heat pipe . It has many advantages such as uniformity of temperature profile , efficiency of heat transfer etc.

  24. 对Sheng和Peck的辐射传热冷冻干燥模型进行简化,将该模型中升华阶段物料干燥层的误差函数温度分布近似为线性分布。

    A simplification for Sheng and Peck 's freeze-drying model with heat radiation has been made in this paper . Linear distribution of temperature within the dried layer during sublimation is assumed instead of the error function profile proposed by Sheng and Peck .

  25. 结合8个典型算例,对检修库内空气速度分布、温度分布、热舒适度指标PMV分布及列车表面的热流密度进行了模拟,确定了合理的送风口位置和最佳的送风参数。

    Based on eight typical cases , simulates the air velocity distribution , air temperature distribution , PMV distribution and heat flux density through the train surface , and finds proper locations of air supply inlet and optimal air supply parameters .

  26. 利用RETRAN模型来评估乏燃料贮存水池稳态和瞬态的热工水力安全分析既方便,又精确,还可用于申请许可证的计算和估算水池的温度分布。

    RETRAN model of nodal calculations is convenient and accurate in thermo-hydraulic analysis of SFP either on steady-state or transient conditions , and can be used for licensing applications as well as best estimate of SFP temperature .

  27. 热激励微梁谐振器的温度分布和谐振振幅

    Temperature Distribution and Resonance Amplitude of Thermally Excited Micromechanical Beam Resonators

  28. 电潜泵井井筒温度分布模型的建立及应用

    Modeling of temperature distribution in well bore with electric submersible pump

  29. 高拱坝近坝库水温度分布研究

    Study on Reservoir Water Temperature Distribution Close to High Arch Dam

  30. 预测井筒压力及温度分布的机理模型

    Mechanism Model for Predicting the Distributions of Wellbore Pressure and Temperature